• Description

    The Up the Ladder is one of my favorite tabled false shuffles. With the right speed and rhythm the shuffle looks very much like a legitimate mix of the cards. Practice making the cuts in smooth circular motions.

  • Pre-Requisites

    None

  • Sources

    Charlie Miller

  • Deck Used

    Expert At The Card Table Deck

5 replies
  1. geometry dash 3d
    geometry dash 3d says:

    I discovered this shuffle myself before I watched this video… dang I figured it out just thinking to make table false shuffle… my inspiration was Alex Pandrea’s false table shuffle… like a three packet false cut.

    Reply
  2. Cecil Edward
    Cecil Edward says:

    That tip about keeping the cuts smooth and circular makes a lot of sense, especially when rhythm matters. Speaking of ways to relax in your free time, I’ve been playing Subway Surfers Online lately, and it’s a fun little break when you just want to switch off.

    Reply
  3. Jordan from Kling 4.0
    Jordan from Kling 4.0 says:

    That note about smooth circular cuts really is the difference maker here. Most people rush the strip-out when they first practice the Up the Ladder, which completely breaks the rhythm and flashes the block separation.

    I was actually trying to put together some overhead felt-table b-roll for a video project recently. Fine finger movements usually get messy in generation, but the Kling 4.0 tool I use kept the card edges relatively stable once I locked down a clean starting keyframe of the grip rather than letting the motion wander.

    Reply
  4. subwaysurferstube
    subwaysurferstube says:

    The advice about maintaining smooth, circular cuts is really useful, especially when consistency and rhythm are important. Small technique adjustments can make a noticeable difference in the final result. When I need a quick break from reading or practicing something new, I sometimes play Subway Surfers Online. It’s a fun, casual game that makes it easy to unwind and enjoy a few minutes of downtime.

    Reply

Leave a Reply

Want to join the discussion?
Feel free to contribute!

Leave a Reply

Your email address will not be published. Required fields are marked *